Hello, edk2-devel,
I want to report a issue about edk2 iscsi:
Set timeout to 5S and copy a big file from iscsi HDD, disconnect Lan cable
>>5S then connect again, the big file still copy successfully.
BIOS: the latest EDK2
Test steps:
1.Power on and press Hotkey to bios setup, in Advanced menu->iscsi
configuration->mac address.
2.ISCSI initiator name: iqn.
3. Add an attempt:
set: iscsi attempt name: 1
set: iscsi mode: enable/enable for mpio, internet protocol ipv4
Set: Connection retry count: 5, connection establishing timeout to [5000]
Set: enable DHCP, enable get target info via DHCP
Set: authentication type: none
4. Saved and exit, reboot.
5. Boot to shell, type: fs2:(ISCSI HDD).
6. Plug USB 3.0 flash disk to board.
7. Copy a big file from ISCSI HDD to usb.
8. Plug out LAN cable and hold some time( >> timeout time 5s), then plug in
again.
Actual result:
The copy file still can successful with ISCSI after timeout.
Expected result:
The copy file is copied fail with iSCSI after timeout.
Thanks,
Robin
_______________________________________________
edk2-devel mailing list
[email protected]
https://lists.01.org/mailman/listinfo/edk2-devel
