Hello Ting,
What I am trying to do is setting STATIC IP for Initiator. But as per below VFR
content, when we choose IP6 the controls to accept Static IP will be disabled.
Right?
suppressif ideqval ISCSI_CONFIG_IFR_NVDATA.IpMode == IP_MODE_IP6 OR
ideqval ISCSI_CONFIG_IFR_NVDATA.IpMode == IP_MODE_AUTOCONFIG;
-Siva
-----Original Message-----
From: Ye, Ting [mailto:[email protected]]
Sent: Wednesday, July 4, 2018 12:12 PM
To: Sivaraman Nainar; [email protected]
Subject: RE: reg: IP6 based Static IP Configuration in ISCSI
Hi Siva,
No, it is not correct.
In iSCSI UI, if you choose IP6 mode, you still have chance to use static
address. Just NOT click the checkbox of "Enable DHCP".
Thanks,
Ting
-----Original Message-----
From: Sivaraman Nainar [mailto:[email protected]]
Sent: Wednesday, July 4, 2018 2:32 PM
To: Ye, Ting <[email protected]>; [email protected]
Subject: RE: reg: IP6 based Static IP Configuration in ISCSI
Ting,
Let me clarify in detail.
When we have IP4 mode selection in ISCSI we can set both Initiator and Target
with Static Addresses.
But if we choose the IP6 mode by default no setup options available to choose
static and it take DHCP as default. In this case even if we configure IP6 using
IfConfig6, it will override by ISCSI. Is my understanding correct?
Thanks
Siva
-----Original Message-----
From: Ye, Ting [mailto:[email protected]]
Sent: Wednesday, July 4, 2018 7:37 AM
To: Sivaraman Nainar; [email protected]
Subject: RE: reg: IP6 based Static IP Configuration in ISCSI
Hi Siva,
We don't have such plan as I known. For IPv6, we leave it to IP6 driver to
perform source address selection to best match the iSCSI target address.
You could use ifconfig6 to set static IP6 address before you configure iSCSI.
Thanks,
Ting
-----Original Message-----
From: edk2-devel [mailto:[email protected]] On Behalf Of
Sivaraman Nainar
Sent: Tuesday, July 3, 2018 6:44 PM
To: [email protected]
Subject: [edk2] reg: IP6 based Static IP Configuration in ISCSI
Hello,
At present in the ISCSI configuration we are able to specify the Static IP
configuration for IP4 protocol. Is there any plan to support IP6 static IP
configuration in ISCSI Configuration?
-Siva
_______________________________________________
edk2-devel mailing list
[email protected]
https://lists.01.org/mailman/listinfo/edk2-devel
_______________________________________________
edk2-devel mailing list
[email protected]
https://lists.01.org/mailman/listinfo/edk2-devel
