Hi Laszlo, Thanks for your reply. Actually what I see is that VPD (Vital Product Area between addresses 44000->47DFF0 ) is completely wiped which causes the failure to boot! Without the VPD unit cannot boot. I will take a look at the white paper. It would be helpful to know what's the impact of disabling the ability of the firmware to write those non volatile variables to flash.
Samah On Thu, Sep 20, 2018 at 9:48 AM Laszlo Ersek <[email protected]> wrote: > On 09/19/18 16:26, Samah Mansour wrote: > > Hello, > > > > > > Our product uses a Baytrail with Minnowboard Max bios firmware ( version > > 0.93). Every now and then we see SPI flash corruption due to power cuts > > while the unit is booting which causes the unit not to boot anymore. > After > > investigation we noticed that the VPD area is all FFs (address > > 44000->47DFF0). > > > > > > We have noticed that the Bios while booting writes to the flash from > > several places in the code, which is if interrupted most probably is > > causing the corruption. > > > > > > Why is the bios writing all these configurations to flash while booting, > is > > it to optimize boot time? is it ok if we disable the bios writing to > flash > > completely to protect ourselves from corruption? > > The firmware is at liberty to write various non-volatile UEFI variables > during boot. Some of those variables are standardized, some others may > be specific to UEFI drivers (with correspondingly private namespace > GUIDs for the variables). > > Power loss during flash write (and resultant flash corruption) is > expected. My understanding is that the Fault Tolerant Write protocol / > driver, sitting between the FVB (firmware volume block, i.e. flash) > protocol / driver, and the variable write protocol / driver, implements > a kind of journaling. It is described in the Intel whitepaper > > A Tour Beyond BIOS > Implementing UEFI Authenticated Variables in SMM with EDKII > September 2015 > > My expectation has been that the platform should recover from > interrupted writes. That is, for a single given UEFI variable, you > should either see "before" or "after" status, never "middle". (The > whitepaper says that "Individual variable atomicity" is maintained even > through a failed "reclaim", with the help of FTW.) > > If multiple variables should be in sync with each other, that's a > different question. If the variables are not in sync, I think "failure > to boot" may be a reasonable outcome. But, "failure to boot" means a lot > of things, and I hope one should be at least dropped to the setup > utility or the shell. Are you seeing an actual crash? > > Laszlo > _______________________________________________ edk2-devel mailing list [email protected] https://lists.01.org/mailman/listinfo/edk2-devel
