Hi all,
On MinnowMax I work on Windows 8.1 with UART.
In BIOS Setup I enable UART. In LSS & SCC Configuration menu in BIOS
Setup I enable : LSS HSUART #1 Support , LSS HSUART #1 FlowCtrl , LSS
HSUART #2 Support , and LSS HSUART #2 FlowCtrl . But I don't know if I
need to in BIOS Setup in Miscellaneous configuration set UART interface
on Super IO UART, for now I set Internal UART for UART interface.
I install Intel driver (
https://downloadcenter.intel.com/download/24228/Intel-embedded-drivers-for-Windows-8-1-32-bit-
)
and I got two UART controllers.
Problem :
Problem is that I have only one COM port ( COM1) and it is for
debugging. I looking in inf (iaiouart.inf ) file of driver for which
device is , and I find APCI/INT33BC device. The COM1 is device
APCI/PNP0501 .
What I need to do to get COM 2 device ? I saw BaseSerialPortLib 16550
module in MdeModulePkg/Library for what it is this module. Need I add
some module for UART or Serial port in fdf (PlatformPkg.fdf ) file to get
COM2 device, or add COM2 in ACPI_table? Where I can find ACPI_table in
source of firmware?
Best regards,
Anteja
------------------------------------------------------------------------------
Monitor 25 network devices or servers for free with OpManager!
OpManager is web-based network management software that monitors
network devices and physical & virtual servers, alerts via email & sms
for fault. Monitor 25 devices for free with no restriction. Download now
http://ad.doubleclick.net/ddm/clk/292181274;119417398;o
_______________________________________________
edk2-devel mailing list
edk2-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/edk2-devel
