I actually get this output with the RHEL5 xen kernel, i will remove ACPI and build a smaller unprivileged (DomU) kernel. IPTables is updated to 1.3.5 from RHEL5. Didn't got the actual kudzu compiled yet - but it is not really an issue in a DomU :-). regards neobiker
ctserver2:/# xm create -c efw > Using config file "/etc/xen/efw". > Started domain efw > > Linux version 2.6.18-8.1.15.efw2xen ([EMAIL PROTECTED]) (gcc version 3.4.6 > 20060404 > (Endian 3.4.6-8.endian6)) #1 SMP Sun Nov 11 09:56:20 EST 2007 > BIOS-provided physical RAM map: > Xen: 0000000000000000 - 0000000006800000 (usable) > 0MB HIGHMEM available. > 104MB LOWMEM available. > Using x86 segment limits to approximate NX protection > ACPI in unprivileged domain disabled > Built 1 zonelists. Total pages: 26624 > Kernel command line: root=/dev/sda3 ro > Enabling fast FPU save and restore... done. > Enabling unmasked SIMD FPU exception support... done. > Initializing CPU#0 > CPU 0 irqstacks, hard=c077a000 soft=c075a000 > PID hash table entries: 512 (order: 9, 2048 bytes) > Xen reported: 991.951 MHz processor. > Console: colour dummy device 80x25 > Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) > Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) > Software IO TLB disabled > vmalloc area: c7000000-f4ffe000, maxmem 2d7fe000 > Memory: 92684k/106496k available (2246k kernel code, 5480k reserved, 959k > data, 188k init, 0k highmem) > Checking if this processor honours the WP bit even in supervisor mode... > Ok. > Calibrating delay using timer specific routine.. 2482.08 BogoMIPS > (lpj=4964166) > Security Framework v1.0.0 initialized > SELinux: Initializing. > SELinux: Starting in permissive mode > selinux_register_security: Registering secondary module capability > Capability LSM initialized as secondary > Mount-cache hash table entries: 512 > CPU: L1 I cache: 16K, L1 D cache: 16K > CPU: L2 cache: 256K > Checking 'hlt' instruction... OK. > SMP alternatives: switching to UP code > Freeing SMP alternatives: 16k freed > Brought up 1 CPUs > Grant table initialized > NET: Registered protocol family 16 > ACPI Exception (utmutex-0262): AE_BAD_PARAMETER, Thread C0725AA0 could not > acquire Mutex [2] [20060707] > Brought up 1 CPUs > PCI: setting up Xen PCI frontend stub > ACPI: Interpreter disabled. > Linux Plug and Play Support v0.97 (c) Adam Belay > pnp: PnP ACPI: disabled > xen_mem: Initialising balloon driver. > SCSI subsystem initialized > usbcore: registered new driver usbfs > usbcore: registered new driver hub > PCI: System does not support PCI > PCI: System does not support PCI > NetLabel: Initializing > NetLabel: domain hash size = 128 > NetLabel: protocols = UNLABELED CIPSOv4 > NetLabel: unlabeled traffic allowed by default > NET: Registered protocol family 2 > IP route cache hash table entries: 1024 (order: 0, 4096 bytes) > TCP established hash table entries: 4096 (order: 3, 32768 bytes) > TCP bind hash table entries: 2048 (order: 2, 16384 bytes) > TCP: Hash tables configured (established 4096 bind 2048) > TCP reno registered > IA-32 Microcode Update Driver: v1.14-xen <[EMAIL PROTECTED]> > audit: initializing netlink socket (disabled) > audit(1194805247.652:1): initialized > VFS: Disk quotas dquot_6.5.1 > Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) > SELinux: Registering netfilter hooks > Initializing Cryptographic API > ksign: Installing public key data > Loading keyring > - Added public key AB570559F14F4FB8 > - User ID: Red Hat, Inc. (Kernel Module GPG key) > io scheduler noop registered > io scheduler anticipatory registered > io scheduler deadline registered > io scheduler cfq registered (default) > pci_hotplug: PCI Hot Plug PCI Core version: 0.5 > rtc: IRQ 8 is not free. > Non-volatile memory driver v1.2 > Linux agpgart interface v0.101 (c) Dave Jones > Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled > RAMDISK driver initialized: 16 RAM disks of 16384K size 4096 blocksize > loop: loaded (max 8 devices) > nbd: registered device at major 43 > Xen virtual console successfully installed as xvc0 > Event-channel device installed. > netfront: Initialising virtual ethernet driver. > Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 > ide: Assuming 50MHz system bus speed for PIO modes; override with > idebus=xx > Registering block device major 8 > netfront: device eth0 has flipping receive path. > netfront: device eth1 has flipping receive path. > ide-floppy driver 0.99.newide > register_blkdev: cannot get major 8 for sd > usbcore: registered new driver hiddev > usbcore: registered new driver usbhid > drivers/usb/input/hid-core.c: v2.6:USB HID core driver > PNP: No PS/2 controller found. Probing ports directly. > i8042.c: No controller found. > mice: PS/2 mouse device common for all mice > md: md driver 0.90.3 MAX_MD_DEVS=256, MD_SB_DISKS=27 > md: bitmap version 4.39 > TCP bic registered > Initializing IPsec netlink socket > NET: Registered protocol family 1 > NET: Registered protocol family 17 > Using IPI No-Shortcut mode > XENBUS: Device with no driver: device/console/0 > md: Autodetecting RAID arrays. > md: autorun ... > md: ... autorun DONE. > kjournald starting. Commit interval 5 seconds > EXT3-fs: mounted filesystem with ordered data mode. > VFS: Mounted root (ext3 filesystem) readonly. > Freeing unused kernel memory: 188k freed > Write protecting the kernel read-only data: 411k > INIT: version 2.85 booting > Mounting /proc filesystem > > --- > Endian Kickstart Bootprocess Manager... > Starting Essential Services... > Activating swap on device /dev/sda2 > Adding 262136k swap on /dev/sda2. Priority:-1 extents:1 across:262136k > /dev/sda3: clean, 14055/262144 files, 222167/524288 blocks > Checking root filesystem: Success > Mounting root read/write > EXT3 FS on sda3, internal journal > Activating hotplug > Calculating module dependencies... done. > Updating System.map file location > Generating /etc/modprobe.conf > modprobe: WARNING: Error inserting parport > (/lib/modules/2.6.18-8.1.15.efw2xen/kernel/drivers/parport/parport.ko): > Operation not permitted > > modprobe: FATAL: Error inserting parport_pc > (/lib/modules/2.6.18-8.1.15.efw2xen/kernel/drivers/parport/parport_pc.ko): > Operation not permitted > > /etc/rc.d/start/essentials/02hwdetect: line 62: 340 Segmentation fault > kudzu -sq -t 30 > Detecting Hardware > modprobe: WARNING: Error inserting parport > (/lib/modules/2.6.18-8.1.15.efw2xen/kernel/drivers/parport/parport.ko): > Operation not permitted > > modprobe: FATAL: Error inserting parport_pc > (/lib/modules/2.6.18-8.1.15.efw2xen/kernel/drivers/parport/parport_pc.ko): > Operation not permitted > > Initializing USB controllers > /dev/sda4: clean, 457/131072 files, 15722/262144 blocks > /dev/sda1: clean, 46/25688 files, 35565/102400 blocks > Checking other filesystems: Success > Mounting other filesystems > Updating /etc/fstab to reflect removable devices > error opening /etc/updfstab.conf: No such file or directory > --- > > Boot Progress: 32% (12/37) Service: netdrivers > .... > > Endian Firewall Community release 2.2.beta1 > efw-22b1 login: > -- View this message in context: http://www.nabble.com/XEN-2.6.18-8.1.15-Kernel-and-EFW22b1-tf4786994.html#a13694524 Sent from the efw-user mailing list archive at Nabble.com. ------------------------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Still grepping through log files to find problems? Stop. Now Search log events and configuration files using AJAX and a browser. Download your FREE copy of Splunk now >> http://get.splunk.com/ _______________________________________________ Efw-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/efw-user
