We are still having issues with Audio going bad on H.323 calls, I have not tried SIP because the systems I need to connect to at this point do not do SIP. Here is what I found. When we go into the configuration assistant page 7 of 10 where you can setup your audio I have the same problem on every windows system I have tried. When you click on Test Settings after about 4 seconds instead of hearing yourself echoed back this clicking starts. this is the same kind of thing I get when in a H323 call. I have even tried it with the inputs and outputs muted, you can watch the VU meter go nuts. We currently have 2 Polycom Viewstation room systems and I do not see this happen when I call into them. I also tested the H323 with a Codian MCU with a 6 way call and even though I had all the inputs muted on the Ekiga system after about 10 min the clicking started. There seems to be an Audio issue with the Windows version at this time. I have tried now 4 PC's windows XP and 2 laptops Windows XP with the same results. I have gone in and disabled all the audio codec's and enabled each one at a time but have the same problem. I even tried a Windows Vista system but there are way more problems just getting it installed and then working that I gave up. I have tried Wengophone and Gizmo on the same systems without any problems. However we can't use them to connect to our Polycom viewstations and or our Codian MCU at this time because SIP is not supported on our Polycom Viewstations or MCU at this time.
Is anyone using this on Windows XP without problems? If so could you try and run the test settings on the configuration Druid page 7 to see if this happens on your system. Not sure what a -d 4 debug output is. Thanks -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Damien Sandras Sent: Wednesday, May 02, 2007 12:09 PM To: Ekiga mailing list Subject: Re: [Ekiga-list] Speex codec Le mercredi 02 mai 2007 à 11:46 -0400, Masullo, Chris F a écrit : > We have been testing the new Windows version 2.0.9 and it looks like no > matter what Audio Codec you use there is a problem where the audio > starts to click continuously and the CPU on the PC goes to 100%. I have > tried this on 4 windows systems and one Linux system. However if I call > any of my room based systems connecting with G711U (PCMU) then it works. > It is only when it is PC to PC even using PCMU. This looks to be an echo > cancellation issue because right before it goes bad you here a loud > screech and then clicking. I have tried turning on/off silence detection > and echo cancellation but still no luck when calling PC to PC for more > than 30 seconds to a min. I have tried other Sip and H.323 software > products and do not have this issue, so I have to assume the PC are not > the problem Please provide a -d 4 debug output. And also try being a bit more clear about the problem. Your explanation is not very clear. -- _ Damien Sandras (o- //\ Ekiga Softphone : http://www.ekiga.org/ v_/_ NOVACOM : http://www.novacom.be/ FOSDEM : http://www.fosdem.org/ SIP Phone : sip:[EMAIL PROTECTED] _______________________________________________ ekiga-list mailing list [email protected] http://mail.gnome.org/mailman/listinfo/ekiga-list _______________________________________________ ekiga-list mailing list [email protected] http://mail.gnome.org/mailman/listinfo/ekiga-list
