On Fri, 2009-08-14 at 20:19 -0700, Reimundo Heluani wrote: > On Thu, 2009-08-13 at 18:53 +0200, yannick wrote: > > Reimundo Heluani a écrit : > > > Hello List, I am new to SIP and I just built ekiga 3.2.5 from source on > > > a LFS Linux 86x_64 2.6.29.5. I can run the echo test and it works fine, > > > but if I try to use my voipdiscount.com account, about 10 seconds after > > > dialing out it says "User not available" regardless of the phone dialed. > > > > > > The problem is that I don't really know how to start debugging this, is > > > there a debug mode for Ekiga? > > > > > > > Yes, please provide us a debug output: > > http://wiki.ekiga.org/index.php/Debugging_Ekiga#How_to_get_a_debug_output > > > Allright, so I can see this line > > "2009/08/13 12:28:54.066 0:10.376 CallSetup:0xf0358910 SIP > PDU is likely too large (1615 bytes) for UDP datagram." > > is this related to > > http://bugzilla.gnome.org/show_bug.cgi?id=341518 > > and if so, my MTU on my ethernet card can be to 4000 and it still fails. > Also, the echo test still works and the log shows those lines anyways. > Finally, running from another Linux and Ekiga 3.2.0 I can call with > voipdiscount.com and the logs don't show those lines abot the PDU being > too large. > > R.
Ok, so deleting all codecs but gsm I can get the call finally, so I guess it was #34518. I'll play a little with MTU vs. allowing some codecs, could you guys tell me more or less what's a good combination? Thanks, R. > > > > Another issues I have (that may be completely unrelated) are > > > > > > 1) If I check on General Settings --> Disable Network detection, then > > > the Ekiga.net account doesn't register (it says Globally not accepted) > > > > > > > That is not an issue, it only means your current setup prevent > > end-to-end communication and you need a helper for that. Left it uncheck. > > > > > 2) I have pulseaudio running on my system and I have to use the > > > "Default" (PTLIB/ALSA) sink therefore, but my card (and webcam) are > > > constantly bombarded. If I have pavucontrol open and test any sound from > > > Ekiga, the cpu goes to 99% activity and I have to kill he stream. > > > > > > > Does it work better without pulse audio? If so, please report a bug to > > pulse audio. > > > > > I know I'm not giving enough information but I don't really know where > > > to begin, I you could point me in any direction to start debugging I'll > > > be thankful. > > > > > > I just installed ptlib-2.6.4, opal-3.6.4 but no pwlib. > > > > > > Cheers, > > > > > > R. > > > > > > _______________________________________________ > > > ekiga-list mailing list > > > [email protected] > > > http://mail.gnome.org/mailman/listinfo/ekiga-list > > > > > > > > > > _______________________________________________ > > ekiga-list mailing list > > [email protected] > > http://mail.gnome.org/mailman/listinfo/ekiga-list > _______________________________________________ ekiga-list mailing list [email protected] http://mail.gnome.org/mailman/listinfo/ekiga-list
