On 12/12/10 11:07 PM, Victor Bandur wrote:
Hi all,
I sent this message about a week ago but received an automated email that it
was too long, so I've removed the attachment to a web server. Please see
below. Thanks!
I'm trying to run Ekiga 3.2.7 on Gentoo for PowerPC. The folks over at Gentoo
have asked me to report this problem to you.
Ekiga starts up fine, and I can see my own video. But when I place a call to
[email protected]<mailto:[email protected]>, [email protected]<mailto:[email protected]> or
[email protected]<mailto:[email protected]>, after about 30 seconds I get the
response, ``Could not connect to remote host''.
The software versions are,
Ekiga: 3.2.7
Opal: 3.6.8
PTLib: 2.6.7
The output of ``ekiga -d 4'' can be found here:
http://baldur.no-ip.org/ekiga-output.txt.gz. What I did was start Ekiga, try
to place the call to [email protected], then quit.
I see: "PDU is likely too large (1504 bytes) for UDP datagram"
Is this the error to be expected when you have more codecs enabled than
is necessary? What happens if you just enable the base audio codecs (e.g
Speex)?
--
Dave Koelmeyer
http://davekoelmeyer.wordpress.com/
Love Coffee?
http://www.greenbeanhouse.co.nz/
_______________________________________________
ekiga-list mailing list
[email protected]
http://mail.gnome.org/mailman/listinfo/ekiga-list
