Thanks to all who replied, I applied the change to CONIFG_SYS_GPS_PORT_CONFIG that Stefan mentioned and it worked.
Regards, Peter Am 29.11.2010 16:08, schrieb Stefan Strobl: > Hi > > On 11/26/2010 02:42 PM, Peter kuennem...@itb wrote: >> Hello, >> i have successfully got a lite5200b board up and running with >> uBoot and linux kernel 2.6.35.7 including JFFS and squashfs >> file systems in flash. It boots with no problem but I am unable >> to use the network adapter (FEC ETHERNET) from within linux. >> >> If I initialize the NIC from uBoot by issuing a NTP command prior >> to the bootm, the network adapter is working. > > I had this problem too. In my case the problem was caused by an incorrect > port multiplex configuration in U-Boot, see CONIFG_SYS_GPS_PORT_CONFIG (I use > 0x xxx5xxxx, which corresponds to 10/100Mbit > Eth with MD). > > When running any network command under U-Boot the function eth_init() is > called which sets the port conifg correctly. > > Regards, > Stefan. _______________________________________________ eldk mailing list [email protected] http://lists.denx.de/mailman/listinfo/eldk
