Dear Alberto Lozano Souto, In message <[email protected]> you wrote: > > I am trying to mount the file system via NFS, I have configure the > U-boot as in the example in: > http://www.denx.de/wiki/U-Bootdoc/EnvironmentVariables, so like this: > > bootargs=root=/dev/nfs rw > nfsroot=192.168.9.3:/opt/eldk-5.4/powerpc-e500v2/rootfs-sato-sdk > ip=192.168.9.232:192.168.9.3:::TQMP2020:eth0:off console=ttyS0,115200 > ramdisk_size=600000 > > Also have the /etc/exports set. > The message I get is this: > > Filename 'uImage'. > Load address: 0x1000000
It is very bad style to post just snippets of the output. Please alwaus make sure to include the complete outout _and_ the command you were running. Above, you are talking about NFS, but what you show here are looks more like a TFTP download than NFS access. But you did not allow to see us what you actually did, so we can only guess. That's a bad starting point for us... Note that TFTP and NFS are totally different things. > Loading: T T T T T T T T T T > Retry count exceeded; starting again OK, so your network transfers are failing at a low level. Unfortunately you did not include enough output to see which interface was used here, so I can only guess that it might have been eTSEC1 ? Do you have a (working, i. e. tested!) network cable attached to eTSEC1? Does it report a link? [Again, this is vital information you failed to provide!!] Do you have a MAC address set for this interface? Is it a valid MAC address? > Waiting for PHY auto negotiation to complete...... TIMEOUT ! > eTSEC2: No link. > Waiting for PHY auto negotiation to complete...... TIMEOUT ! > eTSEC3: No link. > Speed: 1000, full duplex > Using eTSEC1 device > > Besides this, I don't want it to get the kernel from the nfs but only > the filesystem. Do you know what can be wrong? You throw just snippets of some random output at us, that are from commands that are totally unrelated from what you say you want to do (you show output from a kernel TFTP download, but you talk about mounting the root file system over NFS - which is a Linux task and as such totally unrelkated to U-Boot). Sorry, but due to total lack on vital information we cannot help you. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] While most peoples' opinions change, the conviction of their correct- ness never does. _______________________________________________ eldk mailing list [email protected] http://lists.denx.de/mailman/listinfo/eldk
