Gary, I think you're referring to the BL1 (rather than KBL1).
We used the screw terminals to keep the balun as small as possible for portable use. I don't know of any 'nanners that will fit on the PCB without a difficult modification. However, you could put short, large-gauge, bare wire jumpers into each of the screw terminals, then solder them directly to a triple banana jack.
73, Wayne N6KR On Jun 6, 2004, at 5:58 PM, Gary Lee wrote:
Got the kbl1 kit. Looks pretty nice, I wonder if there are binding posts which would work in place of the screw on connectors? I like to use banana plugs for my balanced lines.
---
http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com
