Folks, I guess I just started removing the KAF2 for filter aligment when I first had to deal with it - then I just continued doing the same 'safe' thing with the DSP2. Since I don't use the KDSP2 on a regular basis, I will bow to the advice better experts. 73, Don W3FPR
"Life is what happens when you are making other plans" (John Lennon wrote it in a book, Mike Cross used it in a song - I don't know who was first) ----- Original Message ----- From: "Vic Rosenthal" <[EMAIL PROTECTED]> To: "Don Wilhelm" <[EMAIL PROTECTED]>; "Elecraft" <[email protected]> Sent: Wednesday, June 09, 2004 3:50 PM Subject: Re: [Elecraft] DSP Filter? > Don Wilhelm wrote: > > > The DSP has the low > > pass filter in place all the time and will cut off the high frequency end of > > the Spectrogram display with these wider filters. > > I don't think this is true, Don. The default filter 1 is a LP filter, > but turning off the DSP disables it. The KAF2, on the other hand, DOES > have a hard-wired LP filter which you need to turn off with the slide > switch on the KAF2 board (or remove the board, as you suggest) when > aligning SSB filters. > > -- > 73, > Vic, K2VCO > Fresno CA > http://www.qsl.net/k2vco > > > _______________________________________________ Elecraft mailing list Post to: [email protected] http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com
