I was going to set my K2 up to scan again when I noticed the scan resume feature notes on page 97. It states: "The frequency will jump up 0.5 kHz to avoid having scan re-lock on the same frequency." How do I get mine to do this? I've never had it jump 0.5 kHz. Is there something I am missing in the scan setup procedure? It scans just fine and then when I hit PF2 it starts at the very same frequency. I normally restart the scan by turning the tuning knob if the thousands place decimal point is blinking. Otherwise I start the scan again and manually tune upward to avoid relocking. How do I get it to work like in the manual? That would be convenient.
Kevin. KD5ONS _______________________________________________ Elecraft mailing list Post to: [email protected] http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com
