Hi Back when this mod first came out I did not have the 1/8 watt resistor for the beta test so I used a 1 meg 1/4 watt in its place. This will work if you remove enough of the rubber bumper to allow the resister to set low enough so it does not contact the bottom cover. Also when you remove the square of masking tape from the heatsink save it to stick on the bottom cover to insulate the resistor and toroid.
Don Brown KD5NDB ----- Original Message ----- From: Mike W<mailto:[EMAIL PROTECTED]> To: [email protected]<mailto:[email protected]> Sent: Thursday, June 17, 2004 7:16 AM Subject: [Elecraft] K2 , R116 alternative ? I'm in UK and missing R116 ( the 1/8w BFO retaining R ) from the K2 kit. Anyone recomend an alternative means of fixing the BFO coil without it ?. I have no suitable 1/8w resistors in stock. _______________________________________________ Elecraft mailing list Post to: [email protected]<mailto:[email protected]> http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm> Elecraft page: http://www.elecraft.com<http://www.elecraft.com/> _______________________________________________ Elecraft mailing list Post to: [email protected] http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com
