On Fri, 18 Jun 2004 12:52:12 -0400, Don Wilhelm wrote: > Stewart, > My memory is foggy for the 'when', but I do recall a time when the K2 did > not remember the mode on a per band basis - it just remembered the last mode > used 30 seconds ago, and so would end up in USB on 80 meters as you stated > in your example. > I know version 2.03 firmware DOES remember the mode on a per band basis - so > if you are using something prior to that level, consider upgrading to the > most recent level. Even at that, if your software sets the mode before > setting the band, you will still end up with the last mode used on the new > band rather than what the software tried to set. > 73, > Don W3FPR
Don, I have checked my firmware, and it is version 2.04 which as far as I know is the latest. The way the old firmware worked could fit the symptoms. I have had a number of email (mainly off the group) which detail the same problem, and the software that is effected. These are the ones I know about. DXlabs - The author is aware of the problem, and has indicated that he will probably change his software to fit (timescale unknown) XMlabs - This software has been modified to cure the problem. Logger32 - On going. They need more information. So that is the state of play as of now. I would appreciate comments from Wayne or Eric. 73 Stewart G3RXQ _______________________________________________ Elecraft mailing list Post to: [email protected] http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com
