OK, go with step 2-3-4 on page 10 "Signal tracing" PLL reference oscillator and VCO On the RF board PIN 1 of U4, PIN 3 of U3 and PIN 6 of U3 also.
With these 3 readouts, both did with the RF probe and the scope (peak to peak value), I will be able check if I'm starting the right way. Maybe it would be interesting if someone could convert the signal tracing chapter when using a standard scope instead of the RF probe. I can take snapshot image with my scope. When I finished building my K2 completly, I would like to do a complete document with snapshot and value that I received during calibration. And later, I will able to recheck if some values change with time, or many others things to check. -----Message d'origine----- De : [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] De la part de Dan Barker Envoyé : 23 juin 2004 09:22 À : Elecraft Objet : FW: RE : [Elecraft] Vrms measurements with oscilloscope I have a 'scope. I have a K2. Be happy to run through, recording Pk-Pk voltages for you. What points do you want measured? Dan / WG4S / K2 #2456 <snip> If someone could provide us some readouts ... with a scope would be really appreciated. </snip> _______________________________________________ Elecraft mailing list Post to: [email protected] http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com
