Hi This is normal most of the time the pot will be at max. Don't worry be happy
Don Brown I have built 5 of them number 6 on its way ----- Original Message ----- From: Paul<mailto:[EMAIL PROTECTED]> To: [email protected]<mailto:[email protected]> Sent: Thursday, July 01, 2004 7:06 PM Subject: [Elecraft] Transverter Alignment Procedure Part 1 Reflector Members, Instructions say : Measure the TP2 near L1 in the upper left corner of the RF board. This is the low-noise amplifier (LNA) bias level. Adjust R13 for between 200 and 275 mV (250 mV nominal). All I can get from R13 fully clockwise is 245 mV. Will this present a problem being at the "fully clockwise" position and being under the rating that is considered the "nominal" setting? This is an identical reading for two separate transverters. Paul K8QT K2/100 #3479 _______________________________________________ Elecraft mailing list Post to: [email protected]<mailto:[email protected]> You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> Help: http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm> Elecraft web page: http://www.elecraft.com<http://www.elecraft.com/> _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
