Line level for "pro" equipment is generally considered to be a nominal (average) level of +4 dBu, where 0 dBu = 0.78 volts rms. For typical, uncompressed speech, the rms value of a sine wave equal to the peaks is usually about 10 dB higher than the average level. Compression or limiting will generally reduce that difference to about 6 dB. Translating that to volts, +4 dBu is about 1.23 volts, 6 dB more is 2.5 volts, 10 dB above +4 is 3.9 volts. The key number there is the peak value of the waveform at clip, which is 1.414 x 3.9 volts = 5.5 volts. So an output stage (or input stage) that handles line level would expect to see a peak to peak swing of 11 volts with a nominal line level signal. But VU meters often swing against the peg, so we need some "headroom" -- another 6-10 dB "just in case." 6 dB more is double the voltage, so that's 22 volts peak to peak.
For consumer (home) equipment, the "nominal" level is roughly 300 mV, with peaks of 1-2 volts. The same math applies, except that virtually all pre-recorded music has already been subjected to considerable peak limiting and compression, so "headroom" is less important. BTW -- forget all that ancient stuff about 600 ohms. Pro audio hasn't used a 600 ohm reference for at least four decades. 600 ohms came from the characteristic impedance of telegraph lines between cities (spaced at a foot or so) where lines were long enough that they needed to be treated as transmission lines. Audio lines are almost never that long (4000 ft or more). Besides, the characteristic impedance of audio cable is on the order of 60-80 ohms (do the math on conductor size and spacing), so if termination WERE used, that's the value that would be required! Modern audio gear has a low (50-100 ohm) output impedance and a high (10K typical) input impedance. Mic input stages have a much lower input impedance (1K typical) to maximize signal to noise. Jim Brown K9YC http:audiosystemsgroup.com On Thu, 1 Jul 2004 19:44:45 EDT, [EMAIL PROTECTED] wrote: >When an input to, or output from an audio device is specified as being "line >level", what exactly does that mean? Is it a specific RMS voltage perhaps? >Its a term that I've heard bandied about over the years but either never knew, > >or have forgotten the precise meaning. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
