Hi all, Getting to the exciting bit of the amp now :-) A quick question about the measurements on page 43 of the manual. There are 4 to check.
D13 Cathode: 90 to 150V (I get 128.3V so ok) U4 pin 8: -5 to -25V (I get -22.6V) TP1: 0 to 0.1V (I get 1.5mV) The last one is where my question is ... J3 +lead: 0V (I get 130mV) Is this acceptable? Everything else seems ok. If not, any ideas on where to look? Ian -- Ian Maude G0VGS Morecambe Lancs UK | [EMAIL PROTECTED] Sysop of GB7MBC, the Morecambe Bay Cluster Running Linux and DXSpider | K2 #4044 Find out about Summits on the Air! Visit the SOTA web site at http://www.sota.org.uk _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
