You are right Don. However, this did not happen with my radio before. But if I fine tune to XXXX.33 and tune to another frequency using the 1khz tuning rate and have a look at my fine tune frequency.... the XXXX.33 holds. This did not happen with my K2 when it wasn't calibrated properly.
----- Original Message ----- From: "Don Wilhelm" <[EMAIL PROTECTED]> To: "David Walker" <[EMAIL PROTECTED]>; "Elecraft reflector" <[email protected]> Sent: Monday, July 05, 2004 11:14 PM Subject: Re: [Elecraft] Tuning Rates and fine tune shift. > Dave, > > >From my observations, if the lower order digits on the frequency display are > different than xxxx.00 when you switch to 1kHz tuning steps, those > undisplayed digits will stay the same as they were. - in other words, if you > were tuned to 7070.35 and go to the 1 kHz tuning the steps will be to > 7071.35, 7072.35 etc. > > Perhaps Wayne will chime in here with the 'real' answer. I never paid a lot > of attention to it and just assumed it was like I said above. > > 73, > Don W3FPR _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
