Hi Brian:
You might check the 3/16" diam x 3/16"long spacers at the 5 points
"H"(pg 35) to insure they are installed *without* lockwashers. Good Luck!
73,
Ken Wagner K3IU
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Brian Wruble wrote:
Hi all: I am just nearing completion of the 100W upgrade to my K2. I am
unable to get the 1/4" 4-40 pan head screws to reach far enough through the
board to "catch" the threads in the heat sink UNLESS I leave off the lock
washers. Without the lockwashers, everything seems to fit perfectly.
I'd appreciate any thoughts or advice on this. Thanks.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
