MC Pretty close.
Actually, on the lower frequencies, longer skip is always possible. So is shorter skip. As you go up in frequency, shorter skip quits happening until you reach the MUF, where essentially the minimum skip length becomes so long that you can't get any skip. So part of the problem is that, at the lower frequencies, there is not only the long skip, but short skip as well. Along with it, all the noise from the short and the long skip that is also reaching your radio. You may have heard of the "Maximum Useable Frequency" or MUF. This is the frequency at which the minimum skip is the longest. Above the MUF, your signal just goes out into space. As you get below the MUF, the long skip remains, but shorter and shorter skip becomes possible as you get lower in frequency. However, there's a bad guy out there ... the D layer. The D layer absorbs your signal, and the lower the frequency, the more it absorbs. Perhaps worse still, the higher the solar flux, that same solar flux that makes the MUF go up, the greater the D layer absorption. So when 10 meters is open, it's quite likely that 80 will be unuseable because of the absorption. However, when the sun quits hitting the D layer, that layer's ionization gradually fades, so conditions on the lower frequencies get better the further past sunset. And that is also why in the summer, when you have more hours of sunlight and the sun is beating down on the D layer more directly, the conditions on the lower bands tend to be poorer. Of course, for the lower power signal, the D layer absorption is more intolerable than for higher power levels. That is why QRPers tend to go to the highest frequency that's open. On 10 meters, where there is virtually no absorption, one watt is as good as 100. On 80, though, it's a different story. Hope this helps a little 72/73 de WB8RCR http://www.qsl.net/wb8rcr didileydadidah QRP-L #1446 Code Warriors #35 ----- Original Message ----- From: "MC Carpenter" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Wednesday, July 14, 2004 8:08 PM Subject: [Elecraft] a few basics please, watt to watt compare Can one of the more experience members help on this one, watt to watt, meaning in the 3 to 5 watt range , the lower the frequency, say 40 meters, at night the longer the skip, there fore the longest contact possible, except in summer when its best in early morning hours round four AM or so. So anyone trying for contacts in mid day would be best to use 10 meters or higher and in winter months, Is this right, the reason is that I never hear anyone on 80 or 160 meters but 10 meters in the day is a circus trying to sort out the over lapping and all the signals sometimes. I am wondering if this is the reason that Elecraft does not have 160 and 80 on there small CW units, I have never heard any signal from South America like Brazil , not even one when DX's, yet I am told there is plenty of action on 160 and 80 in that region of the world _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
