Don's advice is correct...However, sometimes the feet are not the problem...If there happens to be a slight twist in the "chassis", the feet will not contact the table equally and a rock will result...If adjusting the feet does not work, try loosening EVERY screw on the outside of the case about 1/2 turn, meaning ALL screws, top, bottom, rear, etc...Do not loosen the two nuts on the heat sink that hold the final transistors...Set the K2 on the bench with the stand folded and apply downward pressure to the case with one hand while re-tightening all the accessible screws with the other...Try to position the radio so that you can reach all the screws without releasing the pressure...This will force the case to lie flat while the screws are tightened...Turn the radio over and tighten the bottom screws...
Jerry, wa2dkg _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
