Jim, The normal meaning of INFO 080 is that one of the firmware chips is not talking properly with the MCU.
The first thing I would do is remove all options from the K2. If the Info 080 remains, take a look at the voltage supplied to the MCU and IOC as first order of business (and check for 0 volts on the ground pin too), then try another 456 reset. After that I would start tracing the AUXBUS signal path to be certain it is intact. I you have an older level MCU and IOC in hand, put the back level ones in just to see if the INFO 080 goes away (caution, with the keyclick mod installed, you need the latest levels for operation, but the older level should allow you to troubleshoot THIS problem) 73 and Good Luck, Don W3FPR ----- Original Message ----- > Well, next weekend I get to break out the K2 manual again. After two years of > flawless operation my K2 chose to provide me with Info 080 when I turned it > on. 456 reset did nothing to fix it so I get to read the manual further. > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com