Hello all
K2 #4320
during recieve alignment 80 meters is very low and l3
l4 have now effect on the strength of the signal.
Is this in the low pass filter I did a relay reset 065
but that had no effect I have gone back through the
soldering of each of the components In the low pass
and band pass filter of 80 meters but no avail.
I am a little confused about the latching relay I know
that the stripe across the front indicates pin 1 but
how does the numbering sequence go does it go 123456
down the row and then 789 etc back up to the top. In
troubleshooting I was going to verify switching of the
low pass filter to try and trace continuity through
the circuit in the event I have a bad solder joint.
Thanks
David KR4OW
K2#4320
__________________________________
Do you Yahoo!?
Y! Messenger - Communicate in real time. Download now.
http://messenger.yahoo.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
