Thanks for the reply. When I got up this morning and looked at the KX1, I knew I had a senior moment last night! I was looking a de-soldering the pins instead of lifting it out. What do I know, I just built it!
Thanks, Tony W7GO ----- Original Message ----- From: "David Toepfer" <[EMAIL PROTECTED]> To: "Tony Morgan" <[EMAIL PROTECTED]>; "#elecraft" <[email protected]> Sent: Thursday, August 12, 2004 1:02 AM Subject: Re: [Elecraft] KX1 KXB30 Alignment > Simply remove your kxat1, re-jumper pins 1 and 3 of j7 near the antenna jack, > and follow the Receiver Alignment procedure outlined on p45 of your kx1 manual. > Then when this is doen, re-install your kxat1. > > kb3ipe > > dt > . > > --- Tony Morgan <[EMAIL PROTECTED]> wrote: > > > Hi Guys, > > Have almost completed KX1 #770. > > Everything is fine so far. My question is with the KXAT1 installed, how do I > > get to trimmer 20A on the KX1 board? > > In the KXB30 manual, page 7, last step it says to re-align rcvr on 20 mtrs. > > > > Thanks, > > > > Tony W7GO > > > > _______________________________________________ > > Elecraft mailing list > > Post to: [email protected] > > You must be a subscriber to post to the list. > > Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > > Elecraft web page: http://www.elecraft.com > > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
