The PLL is not oscillating--there is no frequency at TP3. It is not the frequency counter. The counter accurately reads the BFO and one side of crystal X1.
I have checked all of the components in the oscillator (all correct, proper polarities) and have checked (many, many times) for any evidence of cold joints, bridges, etc.--everything is clean. The thermistor board looks very good, and to the extent possible (resistance measurements) checks out. The voltages on Q 19 are correct, and I can read a frequency (slightly fluctuating) on the side of X1 connected to L31. The other side of the crystal is dead. Everywhere in the circuit shows voltages, but no frequency--all the way to TP3. One thought I would appreciate comments on: Both of the diodes, D-16 and D-17, when measured in place, show a resistance of 16.35 k between their pins, regardless of polarity. Seemed odd, so I checked another ISV149 diode (D-21) and found that it exhibited a resistance of 25.4 M in one direction, and had an infinite resistance in the other direction. I know that measuring components "in circuit" can lead to erroneous results, and I could be measuring a resistance through RP2, but it seems odd that the resistance would be the same in both directions and is inconsistent with the measurement of D-21. Does it look like the diodes are bad? Any other thoughts on why the PLL is dead? Thanks. HOWARD W. ASHCRAFT, Jr. W1WF _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
