I think the manual says to squeze one of the output toroids until you
get less output on 20m than on 40m, as a sign that the filter is
properly adjusted for harmonic reduction.
When I was building my KX1, I brought it to a PAARA club meeting where
Wayne was speaking, and he looked at my KX1 toroids which were evenly
distributed, and said I needed to follow those instructions in the TX
portion of the manual.
On Sat, 21 Aug 2004 10:11am, Eberhart, Russell wrote:
Into a 50 ohm dummy load, and into 1.0-1.1 SWR antennas, I get about
3.3-3.5 watts out on 40M, 4 watts on 30M, and 3.0 watts on 20M. Have
re-aligned...get the same. Is this typical?
73,
WA5ZNU Leigh
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
