Rich, check the errata. That step has been moved from page 47 to page 64 in the manual. Regards, Brian W3BW
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rich McCabe Sent: Saturday, August 21, 2004 4:42 PM To: Elecraft Reflector Subject: [Elecraft] K2 First Alignment. Good but no XG1 signal I am building my second K2. I bought an XG1 after the first one was complete so did not use it on the other build until after it was running. I am to the point in the process where I just did my first alignment step. Everything was perfect and S meter calibrated fine. There is a note that says if you have the XG1, you can use it to get your 50mv S9 signal at this point. They do not give you much more detail than that. So I attached it to the BNC at the back and nothing. Looking over the schematic It looke like W1 might have to be installed. I did not spend much time looking but that seemed to be the case. So, should you be able to use the BNC and XG1 and get a signal? Seems like the RF board is not far enough along to do that yet. 73, Rich kd0zv _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
