You will probably have to find the correct value by trial and error. I
would recommend setting CAL CUR to 4.0 (which conforms to the 'at least 3.5'
instruction) - or even more and then lower it one step at a time until the
message re-appears - more likely on 10, 12 or 15 meters. The actual setting
will depend heavily on your power supply voltage - lower PS voltage requires
a higher CAL CUR setting.
Once set in that manner, it serves as a quick indicator that the power
should be reduced - because the SWR is higher than it should be, or the
power supply voltage has dropped, etc.
This is normally not an indication of a K2 problem.
73,
Don W3FPR
----- Original Message -----
On my K2/100 I have set the HI CUR to 3.5 but get warnings on some higher
bands. The manual says HI CUR should be set to at least 3.5. Can anyone
recommend what a typical value should be and what value I should not go
beyond.
_______________________________________________
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
