Hello to all. I just finished the alignment and test , Part 1 for my new K2, #4472. I have 2 questions for the group. On initial power up the first time, everything is ok , but the PRE annunciator comes on all the time. The manual says that only the C (cw mode), 7100.00 (freq display) and VFO A annunciator should be on. I can turn the PRE off, but the next time I power up, it comes on again. The second question is the menu display for the "T" character. For example, ST L 040 has for the letter "T", a "E" character with the top horizontal line missing. It is like that for all menu items that have a "T" in them.
Only other problems I has so far was the resistance check on the display board. J1 pin 16 (ICLK) read about 65k ohms not what it should be, between 25 -35K. But U1 pin 2 (ICLK) read good, between 25-35k. It turned out that I didn't have the U1 chip seated all the way in. Hope someone can answer the questions. jerry , n2uz [EMAIL PROTECTED] 2004-10-16 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
