Glenn,
Put the first notation on the same page that calls for installation of the
keycaps. After they are installed, one must be aware of where the soldering
iron is positioned or the nasty smell of melting plastic will fill the
air!!!
The same caution could be observed for the RF board after the relays are
installed. For myself, it is just common sense to be aware of where ALL
portions of the soldering iron are positioned when soldering, but even so -
'bad stuff will happen' occasionally.
73,
Don W3FPR
----- Original Message -----
As I begin starting on K2 # 4277 I recall something about
switches being accidently melted when soldering something on the front
panel board. To avoid this , what
page in the manual do I need to notate as to pay extra attention to
possibly avoiding this problem ?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
