Hi to all, Just finished Part 2 of the basic K2 and having problems with the VCO Alignment. I set the K2 to 4 mhz and connected a DVM to the left side of R30 and I read 8.0 v and can not change it by adjusting L30. I checked the VCO readings and just 4000 and 7300 were on the high side. How many turns can you turn L30? I only seem to get about 1 and 1 half down and i get resistance, don't want to break it.
The manual also says that if you do not get any change in the voltage ( like i have) to "refer to Troubleshooting". Well there is no mention of this in the troubleshooting section that I can find. Any help would be appreciated. Tnx in advance Jerry , N2UZ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
