On Sun, 2004-31-10 at 16:23 -0500, JEAN-FRANCOIS MENARD wrote: > I think you pushed too strong on the plastic knob when you installed > it. You could read in the manual the we must not push to hard to break > it.... You must change the POT. I ordered a few last summer... just in > case... because I broke one that way.
My knobs aren't that tight a fit - they slid on quite easily. Also, this didn't start until a few months later, and has been getting gradually worse. I don't think I broke it during installation - it seems to be wearing out prematurely. > Le 04-10-31, à 16:16, Brian Mury a écrit : > > > My K2 AF gain knob is getting really wobbly, and seems to be getting > > worse. I pulled the knob off and took a look. The plastic shaft on the > > pot is getting loose where it fits into the metal body of the pot. > > Looks > > like I'll need a new pot. > > > > I just built the K2 this summer, so it's still quite new. Is this a > > common affliction? > > > > -- > > 73, Brian > > VE7NGR > > > > _______________________________________________ > > Elecraft mailing list > > Post to: [email protected] > > You must be a subscriber to post to the list. > > Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > > Elecraft web page: http://www.elecraft.com > > > =============================================== > Jean-François Ménard / VA2VYZ / FN45aj > [EMAIL PROTECTED] > Elecraft K2 #4130 > > Site Internet: http://homepage.mac.com/jfmenard > =============================================== > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com -- 73, Brian VE7NGR _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
