Steve,
If your 'scope will indicate down to 20 mv (I assume that is peak to peak),
you should be quite able to use the oscillator shown in the K2 manual - the
lowest expected voltage indicated in the manual is 0.27 Vrms at the 2nd
Crystal Filter Output and that is 756 millivolts peak to peak. In fact,
with a 'scope that sensitive, you could use a signal source of only
one-tenth the 140 mVrms value stated and achieve similar results.
73,
Don W3FPR
----- Original Message -----
Any suggestions or recommendations for a Sig Generator used for applications
such as tracing as described in Appendix E of manual or at elecraft's site.
I am aware of the simple oscillator with 10MHZ crystal that is described
after the Sig tracing section of appendix. I have found that the signal
generated for my scope 199C by fluke needs to be in the order of
20millivolts for the 10 to 1 probes. Any suggestions or "redirection" is
appreciated..hi..hi..
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
