Hi all, I finally fixed the problems I was having on the 160m alignment. I could not get 10W no matter how I tried. Thanks go to Don, W3FPR and Bob, G3VVT for their ideas. In the end, I did not seem to be getting any joy when tuning L3 and L4. L4 I could peak but nothing seemed to be happening with L3 so I took the heatsink off (yet again!). Would you believe the fault had been there since I built the rig and I had never noticed up to this point. On terminal of L3 was not soldered. It must have been making a little on the through plating. Once soldered I now could tune properly on 160m :-) Lots of learning learnt!
72/73 Ian -- Ian Maude G0VGS Morecambe Lancs UK | [EMAIL PROTECTED] Sysop of GB7MBC, the Morecambe Bay Cluster Running Linux and DXSpider | K2 #4044 Find out about Summits on the Air! Visit the SOTA web site at http://www.sota.org.uk _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
