Hello,
just completed my K2 to the Alinment and Test Part II.
Here i have some problems...
With the VCO test I always measure 8v at R30.
The voltmeter reading does not change at all i tune L30 or the VFO.
Thus I have thought T5 am wrongly wound. But no change after rewound it...
The Troubleshooting in the manual was not a big help.
I measured there the following voltages:
Reference Oscillator Output, Pin 1 of U4: 1.1V
VCO Output, Pin3 of U3: 0.4Vpp with an DC offset of 4v
VCO Buffer output, Pin6 of U3: 0.8Vpp with an DC offset of 4v
R30 left side: always 8V
Can someone help me?
73 Peter - HB9DUT
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
