On Fri, 2004-11-19 at 17:44, Ron D'Eau Claire wrote: > Hello Ian: > > It's not your fault! The K60XV was added to the Elecraft lineup after the > transverters. At that time a K2 would always have been set for 5 watts out > to produce 20 watts on 144 mHz. Use the K2 power setting that should > correspond to 20 watts. Understand that Ron thanks. > > Of course, you must also have the transverter connected to the low-level RF > output at the K2, and not to the Antenna BNC as shown in the diagrams in the > section, "Connecting the Transverter to your Elecraft K2 Transceiver" Now I am really confused :-) How am I supposed to set up the transverter then? What connections should be made and what settings should I use? The low level interface does not display 5 watts of course.
> The transverter manual needs a few updates, obviously. Thanks for catching > that! No problems. Take a look at page 56 while you are at it. Is the processor U4, U1 or U6? Also a typo in the second line below figure 42. Ian -- Ian Maude G0VGS Morecambe Lancs UK | [EMAIL PROTECTED] Sysop of GB7MBC, the Morecambe Bay Cluster Running Linux and DXSpider | K2 #4044 Find out about Summits on the Air! Visit the SOTA web site at http://www.sota.org.uk _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
