On 11/23/04 5:00 PM, "jerry" <[EMAIL PROTECTED]> wrote: > Hi all, > > Just putting together the KAT2 and can't find where it says to install R6. I > am on page 7 where I am ready to install P4 and P5( it says that R5 and R6 are > clearly visible). The only mention of R6 was in the beggining, at the 2nd > step, the manual says " Install R3, R4 and R5. Note: R6 (47 ohm) and R5 (470 > ohm) have similar color codes" > Is this a miscue in the manual? > > Jerry, 4472, N2UZ >
Hi Jerry, Do not install R6 at this point in he construction process, even though it is shown in the illustration. You are instructed to install it later after the unit is assembled and tested. If you put it in now, you won't be able to successfully complete the test procedure. 73, Gus Hansen KB0YH _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
