Walt and all,
Thanks for that info - I should have checked the schematic before I opened
my mouth (well fingers anyway).
The jumper must be removed from the mic header. Even though FUNC is not
used in the K2, the front panel is wired so that it COULD be used (for some
future something).
This also means that my statement about your mic being able to be used on
another K2 is also incorrect. -- but everything does work FB if you remove
the configuration jumper.
73,
Don W3FPR
----- Original Message -----
Thanks for sharing this simple, ingenious approach. I did it this
morning.
The only thing I forgot to do the first time was to remove the jumper I
had
across FUNC/5, which kept the FUNC circuit tied to Pin 5. It was obvious
something was wrong, and I quickly realized I needed to remove that
jumper.
Works great now.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
