Well, I didn't pay too much attention to the recent thread concerning solder
stations because I have a less than one year old Weller WESD51. I have been
very happy with it until last night. While working on my KD1JV AT Sprint III
the digital readout starting bouncing all over the place. Sometimes the iron
will heat up and at other times not at all. The temp is reading 850deg most
of the time and I can't set the temp at all.
I guess I could replace the pencil and see if that solves the problem. With
tax and all that would be about $35 but I'm not sure that will solve the
problem.
Anyone had this problem with this station?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
