Hi Tom. If you already have the KPA100, look on the rear panel and you will see an RCA jack marked "PA KEY OUT" between the ground connection and the power connector - this will allow you to key your external amplifier directly - but only if your amplifier has a positive voltage for its keying line. If your amplifier uses a negative voltage keying circuit (like the Collins 30L-1 and some others) you will need to construct an external circuit to key the amp. 73 --don n4hh K2/100 #2028
----- Original Message ----- From: "TMorton" <[EMAIL PROTECTED]> To: "Elecraft" <elecraft@mailman.qth.net> Sent: Wednesday, December 01, 2004 8:11 AM Subject: [Elecraft] K2/100 amp keying? > I would like to be able to key an external amp with my K2/100. I see on the > web site a circuit and a reference to the AMPMODKIT to purchase the parts. > There I see a note that the parts are included in the KPA100 kit. However, I > don't remember building this and don't see a connection point on the back of > the /100 cabinet. Did I miss something? > > 73 > > Tom > > K6CT > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > > -- > No virus found in this incoming message. > Checked by AVG Anti-Virus. > Version: 7.0.289 / Virus Database: 265.4.3 - Release Date: 11/26/04 > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.289 / Virus Database: 265.4.4 - Release Date: 11/30/04 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com