At 10:50 AM 12/19/2004, DR wrote... >and there is NO way I can secure the heat sink cover. Yes, the nylon >shoulder washer is flush with the hole on the transistors and I made sure it >is centered, I even measured the screw to make sure I'm using a 1/2". I did >a search to see if anyone else had a problem with this step but I couldn't >find anything that would give me a hint as to what I'm doing wrong. I REALLY >want to know how the heck this is going to work when all this stuff is on the >back side and it is higher than the standoff spacers.
How much higher? You seem to imply that a 1/2" screw isn't long enough? The screw goes through the PC Board (~1/16"), a fiber washer (<1/16), a 1/8 standoff, a shoulder washer (<1/16), the transistor tab (<1/16), insulator and heatsink (~1/16); total ~3/8, leaving plenty of thread. A "2D" fastener is about 1/4, which should be very close to the fiber washer (<1/16), a 1/8 standoff, shoulder washer (<1/16), the transistor tab (<1/16), and insulator. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com