Pete,
When you power on, the firmware level is being displayed.
That does not normally occur, but it does display like you indicate IF you
hold one or more buttons down while powering on.
Based on that info, do check to see that all buttons move freely in the
front panel button holes. If you can't locate one or more tight buttons,
remove the front panel from the board, take off the keycaps and put it
together without the keycaps - just to see if everything then works. If it
does, then you just have to find out why the keycaps bind on the cutouts -
it is difficult to position the switches wrong, so you could have a bad
front panel. I had a bad one once, it was punched just a wee bit crooked
(only about 2 mm off from a corner to corner measurement), and it was very
difficult to see visually - and I even had a good one to compare with.
73,
Don W3FPR
----- Original Message -----
I am also getting some wierd results on first test. Don recommended a
solder check and I have done this. I have rewetted all the joints on the
control board and display to no avail. I get no "info" messages and
things seem to come up as they should. On switch on I get: "Elecraft"
followed by "2.04P 1.09" then a frequency display. At this point tapping
"display" does nothing. Tapping "menu" a few times brings up the menu.
Now "display" works and brings up 13volts/0.008amps. Tapping "display"
several times again sometimes brings back the frequency display and
sometimes the menu. It always seems to want to go back to the menu by
itself after a few seconds and a lot of flicking backwards and forwards.
"rate" seems to work on frequency and the optical decoder seems to work.
Seems to be a wierd intermittant problem.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
