I have an older K1 serial # 00427. Ijust purchased and assembled the KFL1-4 board and installed it in my K1. I chose to use 40, 30, 20 and 15 meter bands. All went togeather very smooth. The problem started when I went to adjust the trimmers. I followed the procedure as described.10MHz seemed to not have any response. All other bands work smooth as silk. I don't think the 18.100 MHz crystal is oscillating. I don't get any thing when I check it at a point beside C5. All of the relays are working properly. I set it on 30m and turned off the power, removed the board and checked continuity at all the proper points with the relays set and all was OK. What do you guys think. I may have damaged the crystal. Not 100% sure. Any suggestions. Allen kn4ud
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
