On Fri, 31 Dec 2004 08:42:38 -0800, Vic Rosenthal wrote: > Stewart Baker wrote, > >>>> Since my original mail I have found that this anomaly only occurs when >>>> on >>>> transmit, and is independent of whether RF is being generated or not. >>>> >>>> I quite often vary my power during a transmission to get signal reports >>>> on different station configurations e.g speech processing, antennas, >>>> microphones, etc. >>>> >>>> This does not really effect my station operation, but is a minor >>>> irritant in that I cannot rely on the LEDS always showing the correct >>>> status >>>> of my K2/100 power out, as the manual says that they should. >>>> I will probably disconnect the LEDS, as at present they are rather >>>> confusing. >>>> > I have a simpler solution: let go of the PTT when changing power output.
Yup - that would do it.. 73 Stewart G3RXQ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
