The mechanicals are done. Just need to order a male DC plug for the Aux 12VDC inside the KAT100, get the 10pin ribbon cable assembly and mount the SO-239s and aux fan.
Here are some shots of what a K2-plus-1 looks like: http://www.k2ta.com/k2plus1_front1.jpg http://www.k2ta.com/k2plus1_front2.jpg http://www.k2ta.com/k2plus1_side1.jpg I had to drill a pair of holes in the K2 bottom cover/rear panel heat sink for a pair of screws. I may remove them at some point and use threaded rods/nuts instead. But this was all done with just the hardware left over from when I removed the bail and feet from the k2 so I used what I had. http://www.k2ta.com/k2plus1_screw.jpg Here's the trick to mounting the KAT-100 front panel flush with the K2. The lower 2d connector has had its threads drilled out and the 4-40 screws from the bail assembly screw into the upper 2d in the K2. http://www.k2ta.com/k2plus1_2d.jpg It's really nice to have a K2/100 with built-in auto-tuner and paddle that can be held between the fingers and thumb of one hand and taken anywhere. 73 de Tom K2TA K2+1 #1117 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
