While doing a mod through shear carelessness I put a short on the front
panel board .When I returned power to the K1 it functioned perfectly
except that it will not now read the battery voltage (reads 0 volts).
I have checked the potential devider R6 /R7 and 6 volts is supplied to
pin3 (RA1) of the MCU which is correct.This MCU input acts as a A to D
converter to read battery volts and also acts as an output to switch the
RIT on and off. The RIT is still switching ok.
As I can find nothing wrong am I right in concluding that the MCU has
been damaged in someway.
Any help will be gratefully appreciated.
Regards
Dave
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
