David,
You have 3 pieces of Elecraft gear connected together - check to see which
one of them creates the problem.
First, just move the antenna to the base K2 to see if you can hear there -
if so, next move it direct to the KPA100 antenna connector - if you can
still hear the signals, the problem is with the KAT100. Once you determine
which Elecraft box contains the problem, we can help more.
OTOH, if you have the K160RX option installed, be certain Rant is set off on
80 meters. The receive antenna setting is remembered on a per band basis.
As a quick check, just connect an antenna to the receiveng antenna jack.
73,
Don W3FPR
----- Original Message -----
I set my k2 up two days ago after a long time idle and hooked up an 80
dipole
I was tuning around on 80 meters and it sounded dead but when I switched
the
antenna to my Kenwood ts450 the band came to life. so it appears that my
k2
with remote kpa100 and tuner seems to be deaf the last thing I had done to
the unit was the shield mod on the kpa 100 did not have a chance to check
it
out after words so any ideas as to where to begin?
see ya
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
