Hello everyone.
Just to add my thanks along with many and say thanks again to Tom for a
nicely
done kit.
This was my first venture into SMD and the hand holding provided by the
instructions
made it painless. Small kits in this realm is the way for me. I couldn't
envision
all the small parts for a K2 laying around here.
As has been suggested around here I started by putting all the parts
into a pie plate.
Use a wooden clothes pin as a based to hold the pc board. Then I cut up
a wire coat hanger and use the hook end together with a tooth pick to
keep the small thingys in place.
Used a program called TuneWin to help me with the adjustment and double
sticky taped
the board as described.
Here are some picture of my adventure.
<http://pages.sbcglobal.net/n2fq/spotIndicator.html>
I should have gotten another one for my 703 :-(
Thanks to the reflector and those who are in the know.
take care.
--
73
Fernando N2FQ/NNNØJYM
San Jose, CA
<http://pages.sbcglobal.net/n2fq>
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
